Accent L4-1.6L (2003)
Control Module: All Technical Service Bulletins
Engine Controls - Service Manual Revision
Group: ENGINE ELECTRICAL
Number: 03-36-018
Date: SEPTEMBER, 2003
Model:
2003, 2004 ACCENT
Subject:
MULTIPURPOSE CONNECTOR DELETED 2003 & 2004 MODEL YEAR ACCENT (2003, 2004 ELECTRICAL - TROUBLESHOOTING
MANUAL CORRECTION)
DESCRIPTION:
The Multipurpose Check Connector (Connector # M69) has been deleted from the Accent beginning with the 2003 Model Year.
The Accent is no longer equipped with a separate ECM/TCM (two separate modules), but is now equipped with a PCM (one module for both Engine and
Automatic Transmission Controls).
The Bosch PCM Installed in 2003 Model Year (and newer) Accents does not require the use of the Multipurpose Check Connector for reprogramming of
the TCM.
Previous to the 2003 Model Year, the Multipurpose Check Connector was used to reprogram the TCM.
The 2003 & 2004 Accent Electrical Troubleshooting Manual (ETM) incorrectly contains information for the Multipurpose Check Connector (which is
no longer being installed). The following pages either show or refer to this connector in error.
^
Page SD-25 shows the Multipurpose Check Connector.
^
Page SD-41 shows pin 8 (MFI Control System). (2003 ETM only).
^
Page SD-60 shows pins 2, 4 & 10 (ETACS).
^
Page CL-7 (picture of the Component Location).
^
Page CC-4 (Connector Configuration).
Write this TSB # at the top of the above mentioned pages in the 2003 & 2004 Accent ETM.
