No Movement in 'DRIVE' or 'REVERSE'
^
If not, check the connector at the TCM and the range switch for a bent pin or pin not fully inserted. Check the wiring harness for an open or
short circuit. If ok, replace the range switch.
11.
Move the shift lever to Drive.
Monitor "Shift Position" and "Select Lever Switch".
^
If "D" and "GEAR 1" are displayed, the TCM is receiving the correct signal from the range switch. Go to Step 12.
^
If not, check the connector at the TCM and the range switch for a bent pin or pin not fully inserted. Check the wiring harness for an open or
short circuit. If ok, replace the range switch.
12.
Install the A/T Tester, P/N 09450-AT000, to the vehicle:
Shift the transaxle to "D". Move the gear selector switch of the A/T Tester and shift manually in 1, 2, 3, 4, and 5 gears (if equipped).
NOTE:
Use the "EF, XG" switch for side-pan transaxles and the "LC" switch for bottom-pan transaxles.
^
Disconnect the A/T Tester from the solenoid. Do not reconnect the harness connector to the solenoid. Shift the transaxle to "R".
^
If no movement, replace the transaxle.
^
If the vehicle moves, check the harness connector at the TCM and the solenoid for a bent pin or pin not fully inserted. Check the wiring harness
for an open or short circuit.
