Accent L4-1.6L (2003)
CAUTION: When installing the clutch, apply grease to each part, but be careful not to apply excessive grease. It can cause clutch slippage and
judder.
2. Apply multipurpose grease into the groove of the release bearing.
Grease: CASMOLY L9508
3. Apply multipurpose grease to the clutch release lever fulcrum contact surface of the clutch release fork assembly.
Grease: CASMOLY L9508
4. Clean the surfaces of the flywheel and pressure plate thoroughly with fine sandpaper or crocus cloth, and make certain that all oil or grease has
been removed.
5. Apply a small amount of multipurpose grease to the clutch disc splines and input shaft splines.
Grease: CASMOLY L9508
CAUTION: Do not apply more grease than necessary. Too much grease can cause clutch slip or judder.
6. Using the special tool (09411-25000), install the clutch disc to the flywheel. When installing the clutch disc, be sure that the surface having the
manufactures stamp is towards the pressure plate.
7. Install the the clutch cover assembly onto the flywheel and install the six (6) bolts through the clutch cover into the flywheel.
8. Diagonally tighten the bolts 15 - 22 Nm (150 - 220 kg-cm, 11 - 15 ft. lbs.).
Tighten the bolts by one or two turns at a time, in succession, to avoid bending the cover flange.
9. Remove the special tool.
10. Install the transaxle.
