Accent L4-1.6L (2003)
12.
Carefully align the manual valve on the valve body to the manual control shaft and reinstall the valve body. Install the bolts and torque to 7-9 lb.ft
(100-120 kg.cm).
13.
Reinstall the temperature sensor to the bracket.
14.
Push the solenoid connector through the hole in the case. Reinstall the clip on the solenoid connector.
15.
Reinstall the oil filter and tighten the bolts to 4-5 lb.ft (50-70 kg.cm).
16.
Install a new pan gasket and reinstall the oil pan. Tighten the bolts to 7-9 lb.ft (100-120 kg.cm).
17.
Add SPIII ATF (approximately 4-1/2 quarts for Accent, 5 quarts for Elantra/Tiburon) and check the level with the engine idling in Neutral.
Confirm the ATF is at the correct level when the ATF is at normal operating temperature (70-100°C, 159-212°F).
18.
Clear the codes and test drive the vehicle for two driving cycles (two key-on to key-off driving cycles, including 1-2-3-4 upshifts and 4-3-2-1
downshifts). If the DTCs return, perform the repairs shown.
PARTS INFORMATION
