Accent L4-1.6L (2003)
Check the wiring harness for an open or short circuit. If ok, replace the range switch.
12. Install the A/T Tester, P/N 09450-AT000, to the vehicle:
^ Shift the transaxle to "D". Move the gear selector switch of the A/T Tester and shift manually in 1, 2, 3, 4, and 5 gears (if equipped).
NOTE:
Use the "EF, XG" switch for side-pan transaxles and the "LC" switch for bottompan transaxles.
^ Disconnect the A/T Tester from the solenoid. Do not reconnect the harness connector to the solenoid. Shift the transaxle to "R".
^ If no movement replace the transaxle.
^ If the vehicle moves check the harness connector at the TCM and the solenoid for a bent pin or pin not fully inserted. Check the wiring harness for an
open or short circuit.
^ If no problem is found swap a TCM from a similar vehicle and test for movement in Drive and Reverse. If the vehicle moves in Drive and Reverse
replace the TCM.
WARRANTY INFORMATION:
Applicable Warranty Applies.
