Accent L4-1495cc 1.5L DOHC MFI (1996)
If the Scan Tool is unavailable, a DVOM may be used to test the sensor. Using a DVOM: Remove the battery and battery tray to access the sensor wire
connector which is located on the transaxle case near the dipstick. Probe the terminals on the sensor side of the connector. Using the chart compare the
ohm value to the temperature.
* Always record the customer's radio stations prior to disconnecting the battery. After completing the test reset the radio to the pre-set stations.
If the ATF oil temperature sensor is not within specification, replace the sensor.
SERVICE PROCEDURE:
1.
Drain the ATF and remove the transaxle oil pan.
2.
Remove the clip that secures the temperature sensor to the valve-body.
