Accent GL Sedan L4-1495cc 1.5L SOHC MFI (1997)
13. Install the special tools as illustrated.
14. Remove the hub from knuckle by turning the special tool.
CAUTION:
-
Be sure to use the special tool.
-
If the hub and knuckle are disassembled by striking with a hammer, the bearing will be damaged.
15. Replace the brake disc with new one.
16. Apply the specified multipurpose grease to the bearings and inside surface of the hub.
17. Remove inner oil seal.
18. Tighten the hub to the knuckle to 230 Nm (167 ft. lbs.) with the Special Tool (09517-21500).
19. Rotate the hub to seat the bearing.
20. Measure the hub bearing starting torque.
-
Tightening torque [Limit]: 1.3 Nm (11 inch lbs.) or less.
21. If the starting torque is O Nm (O inch lbs.), measure the hub bearing axial play.
22. If the hub axial play exceeds the limit while the nut is tightened to 230 Nm (167 ft. lbs.), the bearing, hub and knuckle have not been installed
correctly. Repeat the disassembly and assembly procedure.
-
Hub bearing axial play: 0.11 mm (0.0043 inch) or less.
23. Remove the Special Tool.
24. Apply the specified multipurpose grease to the bearing and to the inside of the knuckle.
-
Recommended grease: Multipurpose grease SAE J310, NLGI No. 2 or equivalent.
