Accent GL Sedan L4-1495cc 1.5L SOHC MFI (1997)
Vacuum Brake Booster: Service and Repair
REMOVAL
1. Disconnect the brake tube from the master cylinder.
2. Remove the master cylinder.
CAUTION: Do not allow brake fluid to remain on a painted surface. Wash it off immediately.
3. Disconnect the vacuum hose from the booster.
4. Remove the operating rod from the brake pedal.
5. Remove the stop lamp switch.
6. Loosen the booster mounting nuts.
7. Lift out the booster assembly.
INSTALLATION
1. When the booster assembly is installed, replace the parking at each end of the booster mounting holder, if necessary.
2. Install brake booster and tighten the mounting nuts.
Tightening torque: 8 - 12 Nm (6 - 9 ft. lbs.)
3. Connect clevis to brake pedal with clevis pin and install the split pin to the clevis pin.
