Accent GL Sedan L4-1495cc 1.5L SOHC MFI (1997)
(d) Install the bottom end of the spring against the front case as shown in the illustration.
5. Secure the tensioner, positioned towards the water pump.
6. Install the timing belt on the crankshaft sprocket.
7. Install the timing belt on the camshaft sprocket.
NOTE:
-
When the timing belt is installed on the camshaft sprocket, make sure that the tension side is tight.
-
Ensure when the tension side is tightened by turning the camshaft sprocket in a reverse direction, all timing marks are in line.
8. Loosen the tensioner mounting bolts 1 and 2 in that order as shown.
NOTE:
-
This will apply spring tension to the timing belt only.
-
Check the belt to ensure that it is not out of position.
9. Tighten the tensioner tightening bolts 1 and 2 in that order.
NOTE:
-
If the bolt 1 is tightened first, the tensioner will move with the belt in the direction that the belt is tightened.
10. Give the crankshaft one turn in operating direction (clock-wise) and realign crankshaft sprocket timing mark with the top dead center position.
NOTE:
-
Do not turn the crankshaft in a counterclockwise direction.The crankshaft should turn smoothly.
11. Loosen the tensioner attaching bolts 1 and 2 in that order.
12. Tighten the tensioner attaching bolts 2 and 1 in that order to 20-27 Nm (200-270 kg. cm., 15-20 ft. lbs.).
13. Then recheck the belt tension as follows:
MANUAL METHOD:
