Accent GL Sedan L4-1495cc 1.5L SOHC MFI (1997)
Condenser HVAC: Service and Repair
REMOVAL
NOTE: For the vehicles not equipped with anti-lock brake system, following procedures - No.1, 5, 6 and 8 - are not necessary. That is, the
condenser can be removed without removing the radiator and fan assembly.
1. Discharge refrigerant from the refrigeration system.
2. Discharge engine coolant from the radiator.
3. Remove two bolts which are holding the radiator upper mounting clamps and the air intake duct.
4. Remove two of the radiator mounting clips and the air intake duct.
5. Disconnect the coolant inlet and the outlet hoses from the radiator.
6. Disconnect oil cooler hoses from the transaxle (A/T only).
7. Disconnect the radiator fan and the condenser fan connectors.
8. Remove the radiator and fan assembly.
9. Disconnect the discharge pipe and the liquid tube (A) from the condenser.
NOTE:
1. Cap the open fittings immediately to keep moisture from entering the system.
2. Be careful not to damage the discharge tube and the liquid tube (A).
3. Be careful not to damage the condenser fins.
10. Remove two condenser mounting bolts.
11. Remove the condenser assembly.
INSTALLATION
1. Installation is reverse of removal.
2. If the condenser is replaced with a new unit, add 25 cc of compressor oil to the compressor.
3. Evacuate, charge and test refrigeration system.