Accent GL Sedan L4-1495cc 1.5L SOHC MFI (1997)
18. Apply semi-drying sealant to the threaded section of the end plug and tighten to 50-70 Nm (37-52 ft. lbs.).
19. Stake the end plug at two points on its circumference with a punch.
20. Install the bushing, rack support, rack support spring and rack support cover in the order shown. Apply semi-drying sealant to the threaded section
of the rack support cover before installation.
21. With the rack placed in the center position, attach the rack support cover to the gear housing. Tighten the rack support cover within the range of
20-25 Nm (14.5-18 ft. lbs.), using the (09565-21100) special tool. Loosen the rack support cover approximately 10°, and tighten the locking nut
to 50-70 Nm (37-52 ft. lbs.).
22. Tighten the feed tube to the specified torque and install the mounting rubber using adhesive.
23. Apply the specified grease, multipurpose grease SAE J310, NLGI No.2 to the bellows mounting position (fitting groove) of the tie rod.
24. Install the attaching band to the bellows.
CAUTION: When the bellows are installed, a new band must be used.
25. Install the bellows in position, taking care not to twist it.
