Accent GL Sedan L4-1495cc 1.5L SOHC MFI (1997)
5. Remove the outer bearing inner race from the hub using special tools (09532-11000, 09532-11301, 09517-21100) or equivalents.
6. Remove the oil seal and inner bearing inner race from the knuckle.
7. Drive out the bearing outer races from the knuckle using the special tools.
CAUTION: If either the outer or inner race needs replacement, they must be replaced as a set.
8. Apply the specified multipurpose grease to the outside surface of the bearing outer race.
Recommended Grease: SAE J310a, multipurpose grease NLGI No. 2 or equivalent.
9. Install the bearing outer race into the knuckle with Special Tools (09500-21000, 09517-21000, 09517-21200) or equivalents.
10. Install the disc to the hub, and torque to specification.
Disc to hub: 50-60 Nm (37-44 ft. lbs.).
11. Apply the specified multipurpose grease to the bearings and inside surface of the hub.
12. Place the outside bearing inner race into the knuckle.
13. Drive the oil seal (hub side) into the knuckle with the special tools.
14. Apply the specified multipurpose grease to the lip of the oil seal and to the surfaces of the oil seal which contact the hub.
Recommended Grease: SAE J310a, multipurpose grease NLGI No. 2 or equivalent.
