Accent GL Sedan L4-1495cc 1.5L SOHC MFI (1997)
18. Measure the hub bearing starting torque.
Hub bearing starting torque [limit]: 1.3 Nm (11 inch lbs.) or less.
19. If the starting torque is O Nm (O inch lbs.), measure the hub bearing axial play.
20. If the hub axial play exceeds the limit of 0.11 mm (0.0043 inch) or less while the nut is tightened to 235 Nm (167 ft. lbs.), the bearing, hub and
knuckle have not been installed correctly. Repeat the disassembly and assembly procedure.
21. Remove the special tool.
22. Apply the specified multipurpose grease to the bearing and to the inside of the knuckle.
Recommended Grease: SAE J310a, multipurpose grease, NLGI No. 2 or equivalent.
23. Drive the oil seal (drive shaft side) into the knuckle until it contacts the bearing outer race using special tools.
24. Apply the specified multipurpose grease to the lip of the oil seal.
25. Install the parts to the torque specifications.
26. Lower the vehicle to the ground and tighten the knuckle to the lower arm ball joint connecting bolt.
