Accent GL Sedan L4-1495cc 1.5L SOHC MFI (1997)
6. Remove the thrust bearing.
7. Push the overrunning clutch out of the outer race by hand.
ASSEMBLY
1. Install the thrust bearing in the carrier. Be sure that it fits correctly in the carrier.
2. Apply a generous amount of petroleum jelly to the inside of the short pinion to hold the 17 rollers bearings in place.
3. Line up the holes in the rear thrust washer and front thrust washer with the shaft of the carrier.
4. Install the short pinion, spacer bushing and two front thrust washers and align the holes. Use care not to allow the rollers to move out of position.
