Accent GT Coupe L4-1495cc 1.5L DOHC MFI (1997)
Antenna: Service Precautions
INSTALLATION OF RADIO EQUIPMENT
The electronic control system computers have been designed so that external radio waves will not interfere with their operation.
However, if the antenna or cable of the amateur transceiver is routed near the computers, it may affect the operation of the computers. even if the output
of the transceiver is no more than 25 W.
To protect each of the computers from interference by transmitter (hum, transceiver, etc.) the following should be observed.
1. Install the antenna on the roof or rear bumper.
2. Because radio waves are emitted from the coaxial cable of the antenna, keep it 200 mm (8 in.) away from the computers and the wiring harness. If
the cable must cross the wiring harness, route it so that it runs at right angles to the wiring harness.
3. The antenna and the cable should be well matched, and the standing-wave ratio should be kept low.
4. A transmitter having a large output should not be installed in the vehicle.
5. After installation of transmitter, run the engine at idle, emit radio waves from the transmitter and make sure that the engine is not affected.
*STANDING-WAVE RATIO
STANDING-WAVE RATIO If an antenna and a cable having different impedance are connected, the input impedance Zi will vary in accordance with
the length of the cable and the frequency of the transmitter. and the voltage distribution will also vary in accordance with the location. The ratio between
this maximum voltage and minimum voltage is called the standing-wave ratio. It can also be represented by the ratio between the impedance of the
antenna and the cable. The amount of radio waves emitted from the cable increases as the standing-wave ratio increases, and this increases the possibility
of the electronic components being adversely affected
