Accent GT Coupe L4-1495cc 1.5L DOHC MFI (1997)
-
Check the markings on the caps for intake/exhaust identification symbol.
I: Intake camshaft
E: Exhaust camshaft
5. Using sequence shown, tighten the bearing caps to 12-14 Nm (120-140 kg.cm, 9-10 ft. lbs.).
6. Using the camshaft oil seal installer tool No. 09221-21000, or equivalent, press fit the camshaft oil seal.
NOTE:
-
Be sure to apply engine oil to the external surface of the oil seal.
-
Insert the oil seal along the camshaft front end and install by driving the installer with a hammer until the oil seal is fully seated.
7. Install the camshaft sprocket then tighten retaining bolt to 80-100 Nm (800-1000 kg.cm, 59-74 ft. lbs.).
8. Align the camshaft sprocket and crankshaft sprocket timing marks. The piston in the No.1 cylinder will then be at the top dead center on the
compression stroke.
