Accent GT Coupe L4-1495cc 1.5L DOHC MFI (1997)
3. With the return spring compressed, using the special tool (09453-24000) or equivalent, and a spring compressor, remove the snap ring, then the
spring retainer and the return spring.
4. Remove the piston from the retainer.
5. Remove the D-section rings from the inner and outer circumferences of the piston.
INSPECTION
1. Check to see if the sliding surface of the disc, plate are worn or burnt, if necessary, replace them.
NOTE: If the lining of the disc is peeling off, replace all discs.
2. Check that the check ball is free by shaking the piston.
ASSEMBLY
1. Install the D-section ring in the groove on the outside surface of the piston with its round side out. Install another D-section ring to the front clutch
retainer.
2. Apply Automatic Transmission Fluid (ATF) to the outside surface of the D-section rings. Then push the piston into front clutch retainer by hand.
3. Install the return spring and spring retainer.
4. Compress the return spring with special tool (09453-24000) or equivalent, and install the snap ring.
