Accent L L4-1495cc 1.5L SOHC MFI (2001)
-
Do not drop the air bag module or clock spring or allow contact with water, grease or oil. Replace if a dent, crack, deformation or rust are
detected.
-
The air bag module should be stored on a flat surface and placed so that the pad surface is facing upward. Do not place anything on top of it.
-
Do not expose the air bag module to temperatures over 93 °C (200 °F).
-
After deployment of an air bag, replace the clock spring with a new one.
-
Wear gloves and safety glasses when handling an air bag that has already been deployed.
-
An undeployed air bag module should only be disposed of in accordance with the procedures mentioned in the Restraints Systems.
-
When you disconnect the air bag module-clock spring connector, take care not to apply excessive force to it.
-
The removed air bag module should be stored in a clean, dry place.
-
Prior to installing the clock spring, align the mating mark and "NEUTRAL" position indicator of the clock spring, and, after turning the front
wheels to the straight-ahead position, install the clock spring to the column switch. If the mating mark of the clock spring is not properly aligned,
the steering wheel may not completely rotate during a turn, or the flat cable within the clock spring may be severed, obstructing normal operation
of the SRS and possibly leading to serious injury to the vehicle's driver. To inspect the clock spring, refer to the Restraints Systems.
1. Disconnect the negative battery terminal.
NOTE: Prior to doing any further work after disconnection of the battery cable, wait at least 30 seconds.
2. Remove the air bag module mounting bolts (2EA) with an asterix wrench. (Tor-x socket)
Disconnect the horn connector and the air bag module connector, and remove the air bag module.
3. Remove the steering wheel.
4. Remove the knee bolster.
