Accent L L4-1495cc 1.5L SOHC MFI (2001)
34.
Slide the throttle body over the studs and connect the following:
a.
Canister purge valve hose.
b.
Two coolant hoses.
C.
ISCA harness connector.
d.
TPS harness connector.
e.
Throttle cable.
35.
Reinstall the upper stud nuts and lower mounting capscrews (be sure to install the wire harness bracket under the left side capscrew). Torque the
fasteners to 11-15 lb.-ft. (15-20 N-m).
36.
Secure the two coolant hoses to the main wiring harness using the supplied hose strap (P/N 17993-19000).
37.
Reinstall the upper air filter housing, Mass Air Flow, and air duct from the throttle body as a single unit.
38.
Reassemble the following:
a.
Mass Air Flow connector
b.
The breather hose at the air duct.
c.
Tighten the hose clamp at the throttle body.
d.
Snap the latches for the upper air filter housing.
39.
Refill the cooling system with coolant.
40.
Reconnect the battery's negative (-) terminal, program the customer's preset radio stations, and reset the clock to the correct time.
41.
Start the engine and check to be certain no coolant or vacuum leaks are present.
42.
Destroy the removed throttle body to render it useless and unusable prior to discarding.
Instructions For Kit # 2 and # 3 - PCV Relocation
