Accent L L4-1495cc 1.5L SOHC MFI (2001)
CAUTION: Measure the pinion preload through the entire stroke of the rack.
2. If the measured value is out of specifications, first adjust the yoke plug, then re-check the total pinion preload.
3. If the yoke plug adjustment does not reach the total pinion preload, check or replace the yoke plug components.
TIE ROD SWING RESISTANCE
1. Give 10 hard swings to the tie rod.
2. Measure the tie rod swing resistance with a spring scale.
Tie rod swing resistance (standard value): (2 - 5 Nm (20 - 50 kg-cm, 17 - 43 inch lbs.))
3. If the measured value exceeds the standard value, replace the tie rod assembly.
NOTE: Even if the measured value is below the standard value, a tie rod that swings smoothly without excessive play may be used. If the
measured value is below 4.3 N (0.9 lb)[100 Nm (8.7 inch lbs.)], however replace the tie rod.
BELLOWS INSPECTION
1. Inspect the bellows for damage or deterioration.
2. Make sure the bellows are secured in the correct position.
3. If the bellows are defective, replace them.
DISASSEMBLY
1. Remove the tie rod end from the tie rod.
