Accent L Hatch Back L4-1495cc 1.5L SOHC MFI (2000)
3. Assemble the piston and piston boots according to the following procedure.
1. Apply rubber grease to the caliper bore, the outside surface of the piston and the piston boot.
2. Install the piston boot on the piston as illustrated.
3. Insert the piston boot in the inner groove of the caliper and slide the piston into the caliper.
4. Assemble the sliding parts according to the following procedure.
1. Apply rubber grease to the outside surface of the sleeve and pin, pin and sleeve bore of the caliper, pin boot and sleeve boot.
2. Insert the boots into the groove of the caliper.
5. Install the pads.
NOTE: Do not apply grease to the disc or pads.
6. Tighten the brake hose connecting bolt.
Tightening torque
Sliding pin: 34 - 44 Nm (350 - 450 kg.cm, 26 - 33 ft. lbs.)
Sliding bolt: 22 - 31 Nm (220 - 320 kg.cm, 16 - 23 ft. lbs.)
Carrier mounting bolt: 64 - 74 Nm (650 - 750 kg.cm, 48 - 54 ft. lbs.)
Brake hose mounting oil bolt: 25 - 29 Nm (250 - 300 kg.cm, 18 - 22 ft. lbs.)
NOTE:
1. Check that the surface of the pin and bolts are not damaged before tightening.
2. Bleed the system. Depress the pedal several times and check for fluid leakage from all connecting parts.
