Accent L Hatch Back L4-1495cc 1.5L SOHC MFI (2000)
Contents For Kit # 1 (P/N) 26700-22000-D):
INSTRUCTIONS FOR KIT # 1 - THROTTLE BODY AND PCV RELOCATION:
1.5 L Accent: Produced through January 31, 2001
1.
Record the customer's preset radio stations, then disconnect the battery's negative (-) terminal.
2.
Disconnect the following:
a.
Mass Air Flow, Idle Speed Control, and Throttle Position Sensor connectors.
b.
The breather hose at the air duct.
3.
Loosen the hose clamp at the throttle body to loosen the duct.
4.
Unsnap the latches for the upper air filter housing.
5.
Remove the upper air filter housing, Mass Air Flow, and air duct from the throttle body as a single unit.
6.
Remove the capscrews and mounting nuts, then remove the throttle body from the vehicle.
7.
Remove the canister purge valve hose at the throttle body, and disconnect the throttle cable.
8.
Place a shop rag over the end of the surge tank to capture the expansion plug.
9.
Insert a long punch (Snap-On PPB1226 or equivalent) through the bore of the surge tank. Using a hammer, gently tap the expansion plug out of
the opposite end (passenger side) of the surge tank.
CAUTION:
Be careful not to hit the punch onto the aluminum surge tank. Be sure the punch is directly on the expansion plug.
10.
Clean the bore of the surge tank with a shop rag and solvent.
