Accent L Hatch Back L4-1495cc 1.5L SOHC MFI (2000)
15.
Mix a small amount of 3M adhesive (P/N DP460) and apply it to perimeter of the PCV elbow and surge tank. Use a small brush to get the area
behind the elbow/hose.
16.
Remove the PCV hose from the surge tank and PCV valve, and discard. Save the hose clamps.
17.
Insert the rubber vacuum cap (P/N 28325-22070) over the hose fitting on the surge tank. Install one of the hose clamps from previous step over the
rubber vacuum cap.
18.
Install the PCV valve insulation (P/N 26719-23010) over the PCV valve.
19.
Install the PCV hose (P/N 26721-22611-D) onto the PCV valve.
20.
Remove the bungee cord from the throttle body.
21.
Reinstall the upper air filter housing, Mass Air Flow (if applicable), and air duct from the throttle body as a single unit.
22.
Reassemble the following:
a.
Mass Air Flow connector (if applicable).
b.
The breather hose at the air duct.
c.
Tighten the hose clamp at the throttle body.
d.
Snap the latches for the upper air filter housing.
23.
Reconnect the battery's negative (-) terminal, program the customer's preset radio stations, and reset the clock to the correct time.
24.
Start the engine and check that no vacuum leaks are present.
