Accent L Hatch Back L4-1495cc 1.5L SOHC MFI (2000)
21.
Use strap (P/N 17993-22000) and make two marks; one at 160 mm (6.3 inches) and one at 175 mm (6.9 inches). The marks on the strap will be
used as a template in the next step.
22.
With the marked strap and measuring from the dash panel, make a mark on the driver side heater hose that matches the 175 mm mark.
23.
With the marked strap and measuring from the dash panel, make a mark on the passenger side heater hose that matches the 160 mm mark.
24.
Relieve any cooling system pressure by removing the radiator cap. Reinstall the cap after the pressure is relieved.
25.
Place a drain pan under the engine approximately where the heater hoses are located.
26.
Cut the passenger side heater hose at the mark with heater hose cutters (Snap On P/N PWC60 or equivalent). Slide a 1/2" hose clamp over each
end of the cut hose.
27.
Install the 180 mm hose (P/N 25414-22955-D) onto the "T" connector (P/N 25412-22955-D).
28.
Install the 180 mm hose/ "T" connector assembly into both ends of the cut heater hose. Orient the tee so that the smaller hose points in the
direction of the throttle body. Slide the 1/2" hose clamps over the tee section of the heater hose.
29.
Cut the driver side heater hose at the mark with heater hose cutters (Snap On P/N PWC60 or equivalent). Slide a 1/2" hose clamp over each end of
the cut hose.
30.
Install the 160 mm hose (P/N 25413-22955-D) onto the "T" connector (P/N 2541 2-22955-D).
31.
Install the 160 mm hose/ "T" connector assembly into both ends of the cut heater hose. Orient the tee so that the smaller hose points in the
direction of the throttle body. Slide the 1/2" hose clamps over the tee section of the heater hose.
32.
Transfer the ISC and TPS from the old throttle body to the new throttle body. Install a new ISC gasket (P/N 35156-33271).
33.
Install a new throttle body gasket (P/N 35101-22601) on the intake manifold.
