Accent L Hatch Back L4-1495cc 1.5L SOHC MFI (2000)
17.
When the "REPROGRAMMING COMPLETED!" message is displayed, the TCM reprogramming process is complete.
18.
Turn the ignition to the OFF position for 20 seconds and then start the engine to check for proper operation.
19.
Check for DTC in the "Engine" and "Automatic Transaxle" menus using the Hi-Scan Pro with SOL card. Erase all DTC.
NOTE:
The following erroneous DTC may be set in the ECM after reprogramming. Erase all DTC:
^
P1765: Torque reduction request
^
P1613: MIL request line - High
^
P1693: MIL request line - MAL
MANUAL UPDATE PROCEDURE:
NOTE:
^
In the event that option "01. LC AT VSS NOISE IMPROVEMENT [AUTO]" fails to download the new TCM program, option "02. LC
AT VSS NOISE IMPROVEMENT [ERROR]" must be used.
^
Confirm all connections are established as shown in the "AUTOMATIC UPDATE PROCEDURE" before continuing.
1.
Turn the ignition to the ON position.
2.
Turn the Hi-Scan Pro ON.
3.
Select option "18. LC AT VSS NOISE IMPROVEMENT" and press ENTER.
