Azera V6-3.3L (2007)
INSTALLATION
1. With a knife, scrape the old adhesive smooth to a thickness of about 2 mm (0.08 in.) on the bonding surface around the entire windshield opening
flange:
-
Do not scrape down to the painted surface of the body; damaged paint will interfere with proper bonding.
-
Remove the rubber dam and fasteners from the body.
-
Mask off surrounding surfaces before painting
2. Clean the bonding surface with a sponge dampened in alcohol. After cleaning, keep oil, grease and water from getting on the clean surface.
3. Install the windshield (A) upper molding (B) and fasteners (C). Do not allow any gaps.
4. Install the spacer (A) install the windshield glass (B) temporarily with marking sure to position them on the center, and then place the alignment
mark (C).
5. Remove the windshield
