Elantra L4-1595cc 1.6L DOHC (1993)
6. Lift tensioner "B" to tighten timing belt "B" so that its tension side will be pulled tight. In this condition, tighten bolt to secure tensioner "B".
When bolt is tightened, use care to prevent shaft from turning together. If shaft is turned together, belt will be overtightened.
7. Check to ensure that timing marks are in alignment.
8. Check to ensure that when center of span on the tension side is depressed with index finger in direction of arrow, deflection of belt is within
specification.
Belt deflection 5-7 mm (0.2-0.3 in.)
9. Install flange crankshaft sprocket onto crankshaft. Be sure to install in the direction as shown in illustration.
CAUTION:
-
Pay attention to direction of flange. If it is installed in wrong direction, a broken belt could result.
For 1.6L Eng:
10. lnstall special washer and sprocket bolt to crankshaft, and then tighten the sprocket bolt.
Tightening torque:
