Elantra L4-1595cc 1.6L DOHC 16 Valve (1995)
Brake Rotor/Disc: All Technical Service Bulletins
Front Brake Disc - Machining Recommendations
Group: CHASSIS
Number: 97-50-007
Date: DECEMBER, 1997
Model: ALL
Subject
FRONT BRAKE DISC MACHINING RECOMMENDATIONS
PURPOSE:
This service bulletin provides front brake disc machining recommendations and procedures to reduce the disc thickness variation that may cause brake
pedal pulsation.
DESCRIPTION:
Hyundai vehicles use two methods of attaching front brake discs. On Excel, Scoupe, Accent, Elantra and Tiburon models, the disc is attached on the
inside of the hub assembly making it less efficient to remove for machining (see illustration). On Sonata models, the disc is attached on the outside of the
hub assembly making it very easy to remove for machining (see illustration).
The following Service Procedures contain front brake disc machining recommendations and procedures for both types of disc attachment methods.
SERVICE PROCEDURE 1 (All models):
Machining of brake discs using an "on-car lathe" is recommended for ALL Hyundai models. An "on-car lathe" provides efficiency and accuracy as it
machines the disc true to the hub's center of rotation. Use an "on-car lathe" made by PRO-CUT (models CROS 700 or PFM 900) or equivalent, and
always follow the lathe manufacturer's instructions for properly machining the brake disc.
SERVICE PROCEDURE 2:
Service Procedure 2 is recommended only if Service Procedure 1 is not available.
^
For the "Inside of Hub" disc attachment design (used on Excel, Scoupe, Accent, Elantra & Tiburon models), follow the steps outlined in Service
Procedure 2A.
^
For the "Outside of Hub" disc attachment design (used on Sonata model only), follow the steps outlined in Service Procedure 2B.
Service Procedure 2A (Excel Scoupe Accent Elantra & Tiburon):
