Elantra L4-1595cc 1.6L DOHC 16 Valve (1995)
Throttle Position Switch: Adjustments
NOTE
-
Since the idle switch (Fixed SAS) is adjusted at the factory, it is not necessary to adjust the idle switch in normal cases except during replacement.
1. Loosen the tension of the acceleration cable.
2. Disconnect the idle switch (fixed SAS) connector.
3. Loosen the idle switch (fixed SAS) lock nut.
4. Turn the idle switch (fixed SAS) counterclockwise until the throttle valve closes.
5. Connect an ohmmeter between the terminal of the switch and the body.
6. Screw in the idle switch (fixed SAS) until continuity is found between the switch terminal and the body, and screw in the idle switch 15/16 turn
from that point.
Tighten the lock nut and connect the idle switch connector.
NOTE
-
Keep the idle switch (fixed SAS) from moving when tightening the lock nut.
7. Adjust the acceleration cable.
8. Adjust the curb idle speed.
9. Adjust the Throttle position sensor.
