Elantra L4-1595cc 1.6L DOHC 16 Valve (1995)
Throttle Position Sensor: Adjustments
1. Connect a scan tool to the data link connector.
2. If a scan tool (ST) is not used, connect a digital-type voltmeter between terminal 13 and terminal 18 of the ECM.
NOTE:
1. Do not disconnect the ECM connector from the ECM.
2. Use a digital voltmeter.
3. Turn the ignition switch to the ON position (do not start engine) and check that the TP Sensor output voltage is as specified. If a scan tool is
used, press code No. 14 and read the voltage.
Standard value: 480-520 mV
4. If it is out of specification, loosen TP Sensor mounting screws and adjust by turning the TP Sensor.
NOTE:
1. Turning the TP Sensor clockwise increases the output voltage.
2. Tighten the screws securely after adjustment.
5. Turn the ignition switch to the OFF position.
