Elantra L4-1595cc 1.6L DOHC 16 Valve (1995)
HARNESS INSPECTION PROCEDURES
SENSOR INSPECTION
1. Disconnect the throttle position sensor connector.
2. Measure resistance between terminal 1 (sensor ground) and
terminal 4 (sensor power).
3. Connect a pointer type ohmmeter between terminal 1 (sensor ground) and terminal 3 (sensor output).
4. Operate the throttle valve slowly from the idle position to the full open position and check that the resistance changes smoothly in proportion with
the throttle valve opening angle.
5. It the resistance is out of specification, or fails to change smoothly, replace the throttle position sensor.
TROUBLESHOOTING HINTS
The Throttle Position Sensor (TP) signal is important in the control of automatic transaxle. Shift shock and other troubles will occur if the sensor
is faulty.