Elantra L4-1595cc 1.6L DOHC 16 Valve (1995)
14. Drive hub side oil seal into steering knuckle, then apply suitable grease to seal lip and hub contact areas.
15. Install inner bearing into knuckle.
16. Using tool hub remover and installer tool No. 09517-21500, or equivalent, assemble hub to steering knuckle. Torque nut on tool to 167 ft. lbs.,
then rotate hub to seat bearing.
17. Measure bearing starting torque. Starting torque should be 11 inch lbs. If starting torque is 0 inch lbs., measure hub axial play. Axial play should
be 0.004 inch with tool nut torqued to specification as in previous step.
18. If starting torque or hub axial play is not within specification, repeat service procedures.
19. Remove service tool, then apply suitable grease to bearing and inside surface of steering knuckle.
20. Drive driveshaft side oil seal into steering knuckle until it contacts bearing outer race, then apply suitable grease to lip of seal.
21. Reverse steps 1 through 6 to install wheel hub and steering knuckle assembly.
