hyundai Workshop Repair Guides

Hyundai Workshop Service and Repair Manuals

Recall: ATM Pressure Control Solenoid Valve|Page 6058 > < Engine Controls - ECU Reprogramming Procedure|Page 6050
Page 1
background image

Technical Service Bulletin # 99-01-002

Date: 990701

Recall: ATM Pressure Control Solenoid Valve

Group: CAMPAIGN

Number: 99-01-002

Date: JULY, 1999

Model: 1999 ELANTRA, TIBURON, ACCENT

Subject
1999 ELANTRA, TIBURON & ACCENT ATM PRESSURE CONTROL SOLENOID VALVE CAMPAIGN (33)

DESCRIPTION:

Some 1999 Elantra, Tiburon and Accent vehicles equipped with automatic transaxles that were produced between 3/25/99 and 4/30/99 may exhibit one
or more of the following conditions:

^

Slips during a downshift from 4th to 2nd gear at approximately 30-55 mph

^

Slips during an upshift from 2nd to 3rd or 3rd to 4th gear

^

Slips when accelerating from a stop or when driving around a curve

^

Slips causing the vehicle to not accelerate or not move

^

DTCs P0732, P0733, P0734 (Non-Synchronous 2nd, 3rd and 4th gear)

The slipping condition is due to a leaking seal under the pressure control solenoid valve (PCSV).

Do NOT replace the transaxle for this condition until you have followed the Inspection Procedure shown below:

INSPECTION PROCEDURE:

Drain the ATF, remove the transaxle oil pan and inspect the ATF. If the ATF is:

^

Clean and no clutch material is found in the oil pan, Follow Repair Procedure.

^

Dark brown or black and clutch material is found in the oil pan, Replace the Transaxle.

PARTS INFORMATION

CAMPAIGN CLAIM INFORMATION:

Recall: ATM Pressure Control Solenoid Valve|Page 6058 > < Engine Controls - ECU Reprogramming Procedure|Page 6050