Elantra GLS Sedan L4-2.0L (1999)
4. Measure the release cylinder bore at three locations (bottom, middle and top) with a cylinder gauge and replace the release cylinder assembly if the
bore-to-piston clearance exceeds the limit.
Limit: 0.15 mm (0.006 inch)
REASSEMBLY
1. Apply specified brake fluid to the release cylinder bore and the outer surface of the piston and piston cup, and push the piston cup assembly into
the cylinder.
Use the specified fluid: Brake fluid DOT 3
2. Install the clutch hose, valve plate, spring, push rod and boot.
INSTALLATION
1. Coat the clevis pin with the specified grease. Align the hole in the end of the release cylinder push rod with that of the clutch release fork shaft and
insert the clevis pin into the holes.
Specified grease: CASMOLY L9508
2. Install the clutch release cylinder and the clutch tube.
