Elantra GLS Wagon L4-2.0L (2000)
25. Take out the spring and the spool.
26. Remove the O-ring from the oil pump switch.
REASSEMBLY
1. Install the oil pump switch.
2. Install the flow control valve spring, valve and connector in the pump body.
NOTE: Apply a thin coat of specified ATF DEXRON II type fluid to all the replaced parts including the oil seal and the O-ring.
3. Install the guide bracket and nut.
4. Using a special tool, install the oil seal into the pump body.
5. Gently insert the shaft assembly and install the snap ring.
6. Install the pump pulley with woodruff key in place.
7. Install the spring and the inner and outer O-rings.
8. Install the front side plate.
