Elantra GLS Wagon L4-2.0L (2000)
9. Insert the pins into the pin grooves of front housing, then install the cam ring, paying attention to its direction.
10. Install the rotor with its punch marked side facing towards the front side plate.
11. Install the vane plates with the round end facing outward.
12. Install the gasket and the rear cover.
13. Tighten the suction connector.
14. Installation is the reverse order of removal.
NOTE:
1. Install the hoses so that they are not twisted and they do not come in contact with any other parts.
2. Install parts by referring to the torque specification.
3. Replenish the fluid.
Recommended fluid Specified PSF - 3 type
4. Bleed the system.
5. Check the oil pump pressure.
INSPECTION
1. Clean all disassembled parts with a suitable cleaning solvent.
2. If any inside parts of the oil pump have been damaged, replace the pump as an assembly.
3. If the pulley is cracked or deformed, replace it.
4. If oil leaks around the pulley shaft oil seal, replace the oil seal.
5. If the serrations of the pulley or pulley shaft are deformed or worn, replace them.
