Elantra GLS Wagon L4-2.0L (2000)
2. Apply grease to the drive shaft and install the boots.
3. Apply the specified grease to the inner race and cage, install the cage so that it is offset on the race as shown.
NOTE: Use the grease included in the repair kit.
4. Apply the specified grease to the cage and fit the balls into the cage.
5. Install the chamfered side as shown, and then install the inner race onto the drive shaft, and install the snap ring.
6. Apply 60 ± 3 gr. (2.1 ± 0.1 oz.) of specified grease to the outer race and install the outer race onto the drive shaft.
7. Apply 40 ± 3 gr. (1.4 ± 0.1 oz.) of specified grease into the D.O.J. boot and install the boot.
8. Tighten the D.O.J. boot bands.
9. Add to the B.J. as much specified grease as was wiped away at the time of inspection.
