Entourage V6-3.8L (2009)
Installation
1. Install the pad retainers (A) on the caliper carrier.
2. Install pad shims (A) and the brake pads (B) with the wear indicator on the inside.
CAUTION:
If you are reusing the pads, always reinstall the brake pads in their original positions to prevent a momentary loss of braking efficiency.
3. Insert the piston in the cylinder using the special tool (09581-11000).
4. Push in the piston (A) so that the caliper will fit over the pads. Make sure that the piston boot is in position to prevent damaging it when pivoting
the caliper down.
5. Being careful not to damage the pin boot, install the guide rod bolt (B) with the specified torque.
6. If caliper assembly was removed, install the brake hose to the caliper.
7. Refill the master cylinder reservoir to the MAX line.
