Entourage V6-3.8L (2009)
4. Remove the left/right mounting nuts (B) of the rear stabilizer bar brackets (A).
5. Remove the rear stabilizer link (A) nut (B) from the stabilizer bar assembly.
Installation
1. Install the rear stabilizer link (A) nut (B) to the stabilizer bar assembly.
Tightening torque :
50 - 65N.m (5.0 - 6.5kgf.m, 36.2 - 47.0lb-ft)
2. Install the bushing (B) on the stabilizer bar (A).
NOTE:
Bring clamp (C) of stabilizer bar (A) into contact with bushing (B).
3. One side bracket should be temporarily tightened, and then install the bushing on the opposite side.
4. Install the stabilizer bracket (A) bolt (B) to the cross member.