Entourage V6-3.8L (2009)
A. Do not scrape down to the painted surface of the body; damaged paint will interfere with proper bonding.
B. Remove the rubber dam and fasteners from the body.
C. Mask off surrounding surfaces before painting.
2. Clean the bonding surface with a sponge dampened in alcohol. After cleaning, keep oil, grease and water from getting on the clean surface.
3. Install the windshield (A) upper molding (B) and fasteners (C). Do not allow any gaps.
4. Install the spacer (A) install the windshield glass (B) temporarily with making sure to position them on the center, and then place the alignment
mark (C).
5. Remove the windshield.
6. With a sponge, apply a light coat of body primer to the original adhesive remaining around the windshield opening flange. Let the body primer dry
for at least 10 minutes.
A. Do not apply glass primer to the body, and be careful not to mix up glass and body primer sponges.
B. Never touch the primed surfaces with your hands.
C. Mask off the dashboard before painting the flange.
7. Apply a light coat of glass primer to the outside of the fasteners.
NOTE:
-
Never touch the primed surface with your hand.
If you do, the adhesive may not bond to the glass Properly, causing a leak after the windshield glass is installed.
-
Do not apply body primer to the glass.
-
Keep water, dust, and abrasive materials away from the primer.
