Genesis Sedan V6-3.8L (2009)
D. Fault 3 - No Input Signal Present
No Input Signal Present is asserted when the Sensor cannot detect a usable input signal from the wiper control for a minimum of 0.5 seconds.
E. Rain Detected
Rain Detected shall be asserted in place of an OFF output in all modes when rain is detected and for 5 minutes following rain detection. Rain
Detected is defined as when the internal Rain Intensity variable is greater 40.
F. Low Speed Request
A Low Speed Request shall be asserted in the automatic mode when the Sensor determines that the wiper system should be operating in Low
speed. A minimum of 5 consecutive output periods and not more than 10 shall be sent to request a single wipe (command wipe).
G. High Speed Request
A High Speed Request shall be asserted in the automatic mode when the Sensor determines that the wiper system should be operating in High
speed.
H. Sensitivity Performance
Sensor sensitivity (ability to respond to various moisture accumulation conditions) performance shall meet the nominal wiper period.
I.
Output Wipe Mode Smoothing/Response Time
The Sensor processing algorithms shall contain smoothing characteristics that prevent erratic wipe transitions. Delay time changes, transitions
between delay and continuous low speed, and transitions between continuous low speed and continuous high speed shall be smooth.
Automatic Mode
When the wiper switch is moved to AUTO position (Wiper Auto Switch=ON & Wiper Int Switch=ON) and (IGN Switch FAM = IGN), the Rain sensor
is considered to be in "AUTOMATIC" mode.
1. If the wiper switch has been left in AUTOMATIC Mode with the vehicle ignition OFF, and then the vehicle ignition switch is turned on, the FAM
transmits single wiping command.
2. The FAM transmits a single wiping command whenever rain has been detected(Rain Detected signal from Rain sensor) and the wiper switch is
moved to the AUTO position. But The FAM does not transmit single wiping command when the wiper switch is moved to the AUTO position and
OFF signal is being received from Rain sensor. But if the wiper switch is moved to AUTO position for the first time since vehicle ignition switch
is turned on then the FAM transmits single wiping command regardless of Rain Detected or OFF signal.
3. Sensitivity Adjustment Function
The drive may adjust the rain sensor performance by adjusting the sensitivity input. When in AUTOMATIC mode, the FAM transmits single
wiping command each time the SENSITIVITY is adjusted upward to a more sensitive setting(downward more then one step). This single wiping
command will only be transmitted if Rain Detected signal is being received from the Rain sensor. If the sensitivity adjustment is adjusted upward
more than one sensitivity, the FAM will transmit single wiping command unless the time between Increases is more than 2 seconds.
Head Lamp Washer Function
1. In case of IGN Switch FAM = IGN & (Tail Lamp LH=ON and Tail Lamp RH=ON)status, if head lamp washer Switch input is detected, head
lamp washer output is turned ON.
2. In case of (IGN Switch FAM = IGN & Head Lamp Low Relay=ON) status, if washer Switch input is detected more T1 time, head lamp washer
output is turned ON.
3. When a washer request arrived during washer activation, the second it's not take in account.
T1,T2,T3 Time is implemented in the FAM EEPROM.
The Outside Mirror Control
The Outside Mirror angle control function and IMS function controls the following devices.
-
Driver side of Outside Glass control motor and 2 potention-meters (vertical and horizontal).
-
Assist side of Outside Glass control motor and 2 potention-meters (vertical and horizontal).
