Genesis Sedan V6-3.8L (2009)
Air Bag(s) Arming and Disarming: Service and Repair
Precautions
General Precautions
Please read the following precautions carefully before performing the airbag system service.
Observe the instructions described in this manual, or the airbags could accidentally deploy and cause damage or injuries.
-
Except when performing electrical inspections, always turn the ignition switch OFF and disconnect the negative cable from the battery, and wait at
least three minutes before beginning work.
NOTE:
The contents in the memory are not erased even if the ignition switch is turned OFF or the battery cables are disconnected from the battery.
-
Use the replacement parts which are manufactured to the same standards as the original parts and quality.
Do not install used SRS parts from another vehicle. Use only new parts when making SRS repairs.
-
Carefully inspect any SRS part before you install it. Do not install any part that shows signs of being dropped or improperly handled, such as
dents, cracks or deformation.
-
Before removing any of the SRS parts (including the disconnection of the connectors), always disconnect the SRS connector.
Airbag Handling and Storage
Do not disassemble the airbags; it has no serviceable parts. Once an airbag has been deployed, it cannot be repaired or reused.
For temporary storage of the air bag during service, please observe the following precautions.
-
Store the removed airbag with the pad surface up.
-
Keep free from any oil, grease, detergent, or water to prevent damage to the airbag assembly.
-
Store the removed airbag on secure, flat surface away from any high heat source (exceeding 85 C/185 F).
-
Never perform electrical inspections to the airbags, such as measuring resistance.
-
Do not position yourself in front of the airbag assembly during removal, inspection, or replacement.
-
Refer to the scrapping procedures for disposal of the damaged airbag.
-
Be careful not to bump or impact the SRS unit or the side impact sensors or front impact sensors whenever the ignition switch is ON, wait at least
three minutes after the ignition switch is turned OFF before begin work.
-
During installation or replacement, be careful not to bump (by impact wrench, hammer, etc.) the area around the SRS unit and the side impact
sensor and the front impact sensors. The airbags could accidentally deploy and cause damage or injury.
-
Replace the front airbag module, SRSCM, FIS when deploying the front airbag. Replace the airbag wiring when the airbag wiring get damaged.
Replace the side airbag module, the curtain airbag module, SRSCM, SIS when deploying the side airbag. Replace the airbag when the airbag
wiring get damaged.
-
After a collision in which the airbags or the side air bags did not deploy, inspect for any damage or any deformation on the SRS unit and the side
impact sensors. If there is any damage, replace the SRS unit, the front impact sensor and/or the side impact sensors.
-
Do not disassemble the SRS unit, the front impact sensor or the side impact sensors.
-
Turn the ignition switch OFF, disconnect the battery negative cable and wait at least three minutes before beginning installation or replacement of
the SRS unit.
