Genesis Sedan V6-3.8L (2009)
5. If the screen indicates "Voltage is OK", select OK. If not, select CANCEL and run the engine for 5 minutes to charge the battery.
6. The progress bar will indicate when reprogramming reaches 100%. Wait until the next screen indicates reprogramming is complete.
7. Turn the ignition switch off for at least 10 seconds, place it back in the ON position and then select OK.
8. The GDS will confirm that TCM reprogramming is successfully finished.
9. When the update is complete, reset the TCM adaptive learning values according to TSB 09-AT-002.
10. Check for any Diagnostic Trouble Codes in the ESC menu and erase any DTC present.
11. Start the engine to confirm proper operation of the vehicle.
1-2. MANUAL TCM UPDATE PROCEDURE:
WARNING:
Manual update should be performed only when the automatic update fails. If automatic update fails, turn the ignition key OFF for about 10 seconds and
turn it back to the ON position to reset the TCM before performing manual update.
1. From the GDS home screen, select ECU Upgrade.
2. From the ECU Upgrade window, select Manual Mode and AT. Select Upgrade Event 147 BH 3.8 TCU IMPROVEMENT. Select BH 3.8 A/T
