Pony Pickup (Canada) L4-1238cc 1.2L SOHC (1986)
/l4-1238cc_1.2l_sohc/Page-157002.png)
2.
Using small needle nose pliers, gently twist the male pins in the pulse generator main connector approximately ten (10) degrees clockwise to
ensure electrical contact.
3.
Reconnect the pulse generator connector.
4.
Remove the connector from the transaxle mounting bracket. Leave the connector loose on the transaxle case to prevent any tension on the harness.
5.
Verify the correct operation of the pulse generator according to the procedure shown.
A.
Connect the HDS Scan Tool to the DLC.
B.
From the Menu, select "4-Speed Trans", "Codes and Data" and "Data".
C.
Drive the vehicle at a steady speed in third gear with the overdrive switch off while an assistant monitors PG-A and PG-B. Check that both
PG-A and PG-B are approximately equal to the engine rpm in third gear. If so, the pulse generators are functioning properly.
WARRANTY INFORMATION:
