Santa Fe L4-2.4L (2001)
REASSEMBLY
1. Clean all components with isopropyl alcohol except for the pad and shim.
2. Install the piston seal.
3. After applying the specified brake fluid to the piston outer surface, install the piston into the cylinder.
4. Install the piston boot and boot ring.
5. Install the guide pin boots and guide pin.
INSTALLATION
1. Install the pads and brake cylinder.
2. Install the brake hose to the caliper.
Bleeder screw tightening torque: 7 - 9 Nm (70 - 90 kg cm, 5 - 6.6 ft. lbs.)
3. Fill the brake reservoir with brake fluid.
4. Bleed the system.
