Santa Fe L4-2.4L (2001)
2.
If you do not already have this software, log on to the Hyundai Service Technology Web Site (www.hmaservice.com) and click on "Hi-Scan
Updates".
3.
Click "Latest Software".
4.
Scroll down to "Reprogramming Software Pack 06-05-01". This software package contains the program required for this procedure plus all
previous reprogramming programs.
5.
Right click on "Reprogramming Software Pack 06-05-01" and then click on "Open".
6.
Select "Run this program from its current location" and click "OK".
7.
After about 20 minutes, the program will open. Just click the "Start" button and the program will automatically copy the file to the correct location.
NOTE:
A Warning message may appear stating "Do you want to install and run R-Repro Pack 06-05-01 .exe from www.hmaservice.com". If so, click the
"Yes" button and the program will continue as mentioned in step 7.
8.
To update the reprogramming card in the Hi-Scan, refer to TSB 00-00-001 for instructions.
IMPORTANT:
BE SURE TO USE THE NEW 16MB REPROGRAMMING SOFTWARE CARD (WITH YELLOW LABEL) WHICH WAS MAILED ALONG
WITH THE NEW CONNECTOR SETS AND TSB 01-36-007 "XG300 PCM REPROGRAMMING".
CAUTION:
Before conducting reprogramming:
1.
Conduct reprogramming with the ignition key in the "ON" position.
^
Be careful not to disconnect any cables connected to the vehicle or the Hi-Scan Pro during reprogramming.
WARNING:
If reprogramming is interrupted, the manual update procedure must be used.
^
Do not start the engine during reprogramming.
^
Do not turn the ignition key OFF during reprogramming.
NOTES:
^
Both the ECM and TCM are reprogrammed during this procedure.
^
If the vehicle is equipped with a manual transaxle, only the ECM will be reprogrammed.
^
Verify that the vehicle is one of the affected vehicles by identifying the vehicle production date.
9.
Remove the Data Link Connector (DLC) cable from the Hi-Scan Pro and attach the Hi-Scan Reprogramming Adapter.
10.
Connect the RED 10-pin connector to the Reprogramming Adapter.
