Santa Fe L4-2.4L (2001)
5.
Remove the radiator shroud mounting bolts (4 each) and oil cooler mounting bolt (1 each) from the radiator support member.
6.
Carefully raise the right lower side of the radiator using a steel bar and remove the oil cooler tube assembly through the rear lower side of the
radiator.
7.
Install the new oil cooler tube assembly and secure it using the supplied new clamps.
NOTE
^
The new oil cooler assembly does not have rubber pads on the tube surfaces.
^
Be careful not to scratch the finish of the oil cooler tube during installation.
8.
Reinstall all removed components in reverse order of removal.
9.
Replenish the ATF with Hyundai SP-III as required (approximately 50 ml).
