Santa Fe V6-2.7L (2003)
Power Steering Pump: Testing and Inspection
OIL PUMP PRESSURE TEST
1. Disconnect the pressure hose from the pump, and then connect the special tool between the pump and the pressure hose as illustrated.
2. Bleed the air. Start the engine and turn the steering wheel several times so that the fluid temperature rises to approximately 50 - 60°C (122 - 132°
F) operating temperature.
3. Increase the engine speed to 1,000 rpm.
4. Close the shut-off valve of the special tool and measure the fluid pressure to confirm that it is within the standard value range.
Standard value
Oil pump pressure
Relief pressure: 7.6 - 8.1 MPa (78 - 83 kg/cm, 1102 - 1175 psi)
CAUTION: Don't keep the shut-off valve on the pressure gauge closed for more than ten seconds.
5. Remove the special tool and then tighten the pressure hose to the specified torque.
Tightening torque 55 - 69 Nm (550 - 690 kg-cm, 40.6 - 50.9 ft. lbs.)
6. Bleed the system.
