Santa Fe V6-3.5L (2004)
5. After removing the ignition key from key cylinder, push "ENTER" key to proceed to the next mode for code saving.
6. Follow steps 1 to 3 and then code saving is completed.
7. Disconnect keyless adapter (09900-21300) from DLC cable and then proceed to self-diagnosis with DLC cable connected.
USING CODE SAVING SWITCH
1. Remove the lower dash panel.
NOTE: Don't disconnect the negative (-) battery terminal.
2. To store new codes :
-
Activate the keyless entry/receiver unit and change code saving switch of the ETACS module from "OFF" to "SET".
-
The secret codes from the transmitter will be stored into the receiver unit when the door lock button or unlock button is pressed on the
transmitter.
-
Save the 2nd transmitter codes in the same manner.
3. Return the code saving switch of the ETACS module from "SET" to "OFF".
4. Install the lower dash panel.