Santa Fe V6-3.5L (2004)
12. Align the solder part (H) of the solder sleeve tube with the center of the overlapped wires.
CAUTION:
Make sure to keep the stripped wires overlapped by holding them with both hands.
13. Subject the solder part (I) to heat. Once the solder is melted, evenly heat the entire solder.
14. After the solder part is melted completely, wait approximately 10 seconds until the solder sleeve tube becomes cold. Pull both ends of the solder
sleeve tube outside slightly, then subject both ends of the solder sleeve tube to heat.
15. Apply the above procedures (step 11 to 14) to the black wire.
